The Module Id of the APIM is 7D0 on the can-bus. Create the USB device and edit the autoinstall.lst file to only install the BT4T-14F500-BE file.įor the long winded explanation, and those that what to put the pieces together.ĪPIM = Accessory Protocol Interface Module it is what holds the software that runs MFT.

*Ford could change this URL and this would no longer work!Ĥ) *This step may not be needed depending on if you are using the PNG file method. *To do non-north america and non-latest software you will need all the proper field values for your vehicle from the as build and from the current software installed on the vehicle.Īll credit goes to flsdiver for the URL/Excel doc/steps needed. You do not need to change anything else in the URL. You can get the ESN number in the settings section on the myfordtouchunit. This appears to be case sensitive so make sure it is all uppercase letters. You will need to replace “YAABBCCD” in the URL section and provide your vehicle’s ESN number otherwise it won’t work. Using the PNG file described here posted by rmcgryĭownload license (BT4T-14F500-BE) from URL attached in the excel document. Not sure needed/what it does but I did it anyway.ģ) New method seems to be either getting a license file from vincentka post 535 ( ) *Unknown if ACM as built data bit needs to be changed yet.Ģ) Program ACM as build with bit mentioned in this thread. Turn key off, turn on, sync black screen for a bit, then performing routine system maintenance. You will also need a ELM327 device that can do HSCAN/MSCAN.ġ) Program APIM using Forscan & ELM327 device. Modify the APIM as-built data using Forscan (you will need to request an extended license for Forscan) As noted by flsdiver in the previous myfordtouch thread

How to get navigation on myford touch